HK3 chicken flap with switching attracting light

The HK3 opens and closes automatic flaps on poultry and chicken coops, aviaries or small animal enclosures at dusk or time or in a combination of both.

Real emergency stop or emergency opening function:

If there is an animal under the slide during the closing process, the motor is automatically stopped and the flap is opened again immediately. The closing process is automatically repeated several times. No animal has to free itself under the weight of the flap, as is usual with all other manufacturers!
This feature can be disabled in the settings.

Optional connection options:

Connection for external button (for manual OPEN and CLOSE operation).
Connection for external remote display.
outside light sensor. (If the HK3 is installed indoors, an external outdoor light sensor is required).
Attracting light 12V 12W.
Wireless remote control (outdoor range: approx. 20 - 30 m)

The following functions can be set on the integrated display:

Date and Time:

Current time
Current date
Summertime

Menu - Languages:

DE (German),
FR (French),
EN (English)
NL (Dutch)

Operating mode:

Operating modes for opening and closing, the combinations between twilight sensor and timer.

time and light

o Opening time for morning. Flap is opened when it is light and the set opening time has been reached. Both conditions must apply.

o Closing time delay for evenings. The flap is closed when it gets dark and when the set closing time delay (in minutes) has been reached or expired. Both conditions must apply.

Time or Light (+ Time Delay)

o One of the set conditions for twilight or time must be reached.

Just time

o Lighting conditions are ignored.

Light only (+ time delay)

o The set % value of the light sensor must be reached. The flap then closes immediately or after the set closing time delay

Manually

o Open and close with button

attract light:

When power is supplied via a 230V / 12V DC plug-in power supply unit or a solar module, an attracting light with a 12V DC 12W light strip can be switched.
Decoy light turns on at dusk and before the hatch closes.

assembly instructions

An external outdoor light sensor is required for indoor installation or if the installation location is in the shade. For wall mounting, only use the 4 pre-drilled openings in the corners of the housing, each next to the cover attachment.
This way no moisture can get into the housing. Assembly instructions on anleitung-jt.de

scope of delivery

HK3 with integrated light sensor, menu-driven display,
dimensions: width 120 mm, length 120 mm, height 55 mm
coiled drawstring
Plug-in power supply 230 V / 12 V DC (approved only for indoor use!)

Pullcord 2m with S-hook

for connecting sliders, chicken flaps or others with flap adjusters from JOSTechnik ! The pull cord is a braided weatherproof 0.6 mm cord, which according to the manufacturer is tear-resistant up to 60 kg load.

the S-hook is very useful to hook up the flap to the gate control unit and to untie it again in a easy way

the lenght of the pullcord is 2 m

JOS Technik - chicken door

JOS Technik - chicken flap with self-locking

made of 2 mm thick aluminum for closing stables, e.g. B. chicken coop.

The flap locks itself when closed. An animal such as a fox, marten, etc. is no longer able to push up this flap!
Locking only works together with flap actuator KS from JOS Technik from version 09/14, JT-HK, HK-ZSU, as well as Poultry House Butler PHB + PHB2... and cannot be retrofitted to existing flaps!
If the flap is attached on the inside, it cannot be pushed up by a person from the outside, making it more secure against theft!

See assembly!

Dimensions:

JOS Technik - duck flap

made of 2 mm thick aluminum for closing stables, e.g. B. Duck coop.

Technical specifications:

JOSTechnik - self-locking flap for duck coops

made of 2 mm thick aluminum for closing stables, e.g. B. Duck coop.

Flap locks itself again when closed. An animal such as a fox, marten, etc. is no longer able to push up this flap!
Locking only works together with flap actuator KS from JOS Technik from version 09/14, JT-HK, HK-ZSU, as well as Poultry House Butler PHB and PHB2... and cannot be retrofitted to existing flaps!
If the flap is attached on the inside, it cannot be pushed up by a person from the outside, making it more secure against theft!

See assembly!

Technical specifications:

made of 2 mm thick aluminium for closing enclosures, such as a goose house for example

JOSTechnik - goose flap for goose coops

made of 2 mm thick aluminum for closing stables, e.g. B. Goose coop.

Flap made of 2 mm thick aluminum for closing stables, e.g. goose house. As a manual goose flap or in conjunction with our flap adjusters as an automatic goose flap.

See assembly!

Technical specifications:

Scope of delivery:

JOSTechnik - self-locking flap for goose coops

made of 2 mm thick aluminum for closing stables, e.g. B. Goose coop.

Flap locks itself again when closed. An animal such as a fox, marten, etc. is no longer able to push up this flap!
Locking only works together with flap actuator KS from JOS Technik from version 09/14, JT-HK, HK-ZSU, as well as Poultry House Butler PHB and PHB2... and cannot be retrofitted to existing flaps!
If the flap is attached on the inside, it cannot be pushed up by a person from the outside, making it more secure against theft!

See assembly!

Technical specifications:

Scope of delivery:

JOSTechnik - Chicken flap for BIO-keeping according to guidelines.
made of 2 mm thick aluminium for closing off housing, e.g. chicken coops.

Flap size fulfils conditions according to the guidelines for BIO husbandry and animal welfare regulations!

Technical data:

Dimensions:

Flaps are available as 2nd choice on request with up to 40% discount. A return of these 2nd choice flaps is excluded.

made of 2 mm thick aluminium for closing enclosures, such as a small animal shed for example

XXL-sized flap gate for small animal shed

made of 2 mm thick aluminium for closing enclosures, such as a small animal shed for example

Technical data:
Flap gate width 485 mm
Flap gate height 740 mm
Slide rail length 1130 mm
Slide rail width 25.5 mm
max. height 1480 mm

JOSTechnik - LDR outdoor light sensor
The LDR outside light sensor is required as an optional accessory if the flap actuator is placed in the interior.
The outdoor light sensor is installed outside the building and connected to the flap actuator using a control line.

Cable length 1m

Available with cable lengths of 1 - 8 meters.

Compatible for JT - KS until March 31, 2017, PSD..., PHB2... and JT-HK+HK-ZSU from 2020!

Cannot be used for PDO, JT-HK up to 12/2019 or KS-SFH!

Double-push-button

with cableas external push-button for manual operation of all damper actuators, but not for PDO and PHB2....

complete with black plastic housing with cable length 1 m

Push-button can be attached using double-sided adhesive tape or screws (drill screw holes in the bottom part of the housing) and dowels! Not included in delivery!

H = 19 mm
W = 38 mm
L = 48 mm

LED-strip-light dimmable 12W / 12V-DC

for light control PLM and PLMmini from JOSTechnik and 12V light systems!

Attention: Only suitable for 12 V DC !!!
This 12 V DC LED lamp as a light bar with bracket can be dimmed without flickering with light controls from JOS Technik. Up to 3 dimmable 12W light strips can be connected directly without a relay module.
If LED components are operated directly with a perfectly smoothed DC voltage (DC voltage without significant ripple noise), these LED lamps also show a flicker value that is negligible in practice and are therefore considered flicker-free.

Technical dataSupply voltage   12 V DC
Energy efficiency category   F
Socket   strip light with mounting clips
Power consumption   12 W
Light flux   1 050 in Sphere (360°)
Lumen per Watt   ≥ 90 lm / W
Beam angle   120°
Colour temperature 2800 - 3200 Kelvin - warm white
Colour rendering index   > 81 RA
Dimmable   yes
Average light bulb lifespan    50.000 hours
Average amount of switching cycles   > 10.000
Dimensions (L x W x H)    340mm x 18mm x 12mm
Ignition time   >0,3 s
Intensity at the end of lifespan    15 %
Temperature range   -20°C - +40°C
Weighted power consumption 12,0 kWh / 1000 h
Luminous efficiency   ≥ 96%
Seconds until 60% of full light flux is reached    0,58 s
Protection class   IP 65
Mercury content   0,0 mg
Max. light intensity (candela)    600 cd

Proper disposal:
Lamps labelled with the WEEE symbol can be returned to suitable collection centres.

LED-strip-light dimmable 6W / 12V-DC

for light control of JOS Technik 12V flap actuators and for 12V lighting systems!

Attention: Only suitable for 12 V DC !!!
This 12 V DC LED lamp as a light bar with bracket can be dimmed without flickering with light controls from JOS Technik. Up to 5 dimmable 6W light strips can be connected directly without a relay module.
If LED components are operated directly with a perfectly smoothed DC voltage (DC voltage without significant ripple noise), these LED lamps also show a flicker value that is negligible in practice and are therefore considered flicker-free.

Technical dataSupply voltage   12 V DC
Energy efficiency category F
Socket   strip light with mounting clips
Power consumption   6 W
Light flux   554 in Sphere (360°)
Lumen per Watt   ≥ 90-100 lm / W
Beam angle   120°
Colour temperature 2800 - 3200 Kelvin - warm white
Colour rendering index   > 81 RA
Dimmable   yes
Average light bulb lifespan    50.000 hours
Average amount of switching cycles   > 10.000
Dimensions (L x W x H)    340mm x 18mm x 12mm
Ignition time   >0,3 s
Intensity at the end of lifespan    15 %
Temperature range   -20°C - +40°C
Weighted power consumption   6,0 kWh / 1000 h
Luminous efficiency   ≥ 96%
Seconds until 60% of full light flux is reached    0,58 s
Protection class   IP 65
Mercury content   0,0 mg
Max. light intensity (candela)    600 cd

Proper disposal:
Lamps labelled with the WEEE symbol can be returned to suitable collection centres.

remote display

Ultra-bright LED lamps for status display of the flaps from JOS Technik, except HK-Bat, HK-Bat-R... , PHB, PHB2... , PHB2R...
Display LED red for open and LED green for closed!

complete with black plastic housing with cable length 1 m

Remote display can be attached using double-sided adhesive tape or screws (drill screw holes in the lower part of the housing) and dowels! Not included in the delivery!

JOSTechnik - radio remote control JT-FB4T

for manual operation of the automatic chicken flap or flap actuator PHB2 and PHB2-R... (not HK-Bat and HK-Bat-R...) . With the radio remote control JT-FB4T you can wirelessly open or close the PHB2 and PHB2-R... and / or switch the lighting on and off, but not dim it.
After operating the radio remote control to open and close the flap , a complete cycle must always be completed before the flap actuator switches back to automatic mode! If the light is switched on manually but not switched off, the lighting is automatically switched off at 11:00 p.m. when the device switches to the night time range.

When ordered together with the flap actuator devices PHB2, the radio remote control is installed. Otherwise easy to retrofit, since it is simply plugged onto the existing connection .
Not suitable if a solar energy set or batteries are selected as the power supply, as the receiver constantly draws electricity!

Scope of delivery:
Radio remote control - 4 buttons with 1 transmitter and 1 associated receiver

Outdoor range: approx. 20 - 30 m

Attention: When retrofitting , the radio remote control must be trained! See note on invoice, delivery note !!!

JOSTechnik - radio remote control JT-FB4T

Outdoor range: approx. 20 - 30 m

Attention: When retrofitting , the radio remote control must be trained! See note on invoice, delivery note !!!

Cable roller

used if complicated closing systems should be implemented ( see assembly examples ).

Technical data:

Substance: POM yellow
outside diameter 40 mm
outside diameter of running surface 25.5 mm
inner diameter of pivot bore 6.2 mm
width 14.2 mm
roller surface radius 4.5 mm

Scope of delivery:

Cable roller 40 mm diameter
Wooden screw for fastening

Deflection roller - Cable roller with bracket

Used as an accessory for gate control units (hen house flap gate, electronic door opener / closer) it is used if complicated closing systems should be implemented see assembly examples.

Technical data:

Substance: POM yellow
outside diameter of roller 40 mm
outside diameter of running surface 25.5 mm
inner diameter of pivot bore 6.2 mm
roller width 14.2 mm
roller surface radius 4.5 mm
bracket made of 3 mm thick aluminium : Width 60 mm
Total height of roller with bracket: 50 mm
diameter of bore holes for fastening 6.2 mm, distance 50 mm

Scope of delivery:

Cable roller 40 mm diameter with bracket made of 3 mm thick aluminium